Parameters of Fake WDS100T2G0A with Firmware V1.002
| General information | |
|---|---|
| Trademark | Fake |
| Model | WDS100T2G0A |
| Capacity | 2 TB (1.8 TiB) |
| Form-factor | 2.5" |
| Type | SSD |
| Interface | SATA |
| SATA version | 3.1 |
| Controller | Realtek |
| Firmware | V1.002 |
| Alternative firmwares | 1 |
| Firmware upgrade | supported |
| ATA version | ACS-3 |
| Advanced Format | not supported |
| Units tested | 7 |
| Times tested | 10 |
| Performance | |
| Maximum interface speed | 600 MB/s |
| Maximum read speed | 417 MiB/s |
| Minimum average access time | 0.5 msec |
| Volatile write cache | supported |
| Read look-ahead | supported |
| Native command queuing (NCQ) | supported |
| Advanced power management (APM) | not supported |
| Device sleep (DevSleep) | supported |
| Clearing unused data (TRIM) | supported |
| Reliability | |
| Count of sensors | 29 |
| SMART command transport (SCT) | supported |
| Full self-test time | 26 minutes |
| Critical maximum temperature | 125°C (257°F) |
| Recommended maximum temperature | 100°C (212°F) |
| Maximum temperature | 40°C (104°F) |
| Average maximum temperature | 37°C (98°F) |
| Security | |
| Drive access restriction | supported |
| Enhanced security erase | supported |
| Data destruction time | 2 minutes |
| Instant data destruction | not supported |
| Host protected area (HPA) | supported |
| Host protected area password | not supported |
| Trusted computing | not supported |