Parameters of ST328040A with Firmware 3.11
| General information | |
|---|---|
| Trademark | Seagate |
| Model | ST328040A |
| Capacity | 28.5 GB (26.5 GiB) |
| Type | HDD |
| Interface | PATA |
| Maximum Ultra DMA mode | 2 |
| Firmware | 3.11 |
| Firmware upgrade | supported |
| ATA version | 4 |
| Advanced Format | not supported |
| Units tested | 1 |
| Times tested | 2 |
| Performance | |
| Maximum interface speed | 33,3 MB/s |
| Maximum buffered read speed | 28 MiB/s |
| Maximum read speed | 25 MiB/s |
| Minimum average access time | 12.30 msec |
| Cache buffer | 512 KiB |
| Volatile write cache | supported |
| Read look-ahead | supported |
| Tagged command queuing (TCQ) | not supported |
| Advanced power management (APM) | not supported |
| Acoustic management (AAM) | not supported |
| Reliability | |
| Count of sensors | 12 |
| Free-fall control | not supported |
| SMART command transport (SCT) | not supported |
| Full self-test time | 35 minutes |
| Temperature sensor | not supported |
| Security | |
| Drive access restriction | not supported |
| Enhanced security erase | not supported |
| Instant data destruction | not supported |
| Host protected area (HPA) | not supported |