Parameters of ST9100822A with Firmware 3.02
| General information | |
|---|---|
| Trademark | Seagate |
| Model | ST9100822A |
| Capacity | 93.1 GB |
| Interface | PATA |
| Maximum Ultra DMA mode | 5 |
| Firmware | 3.02 |
| Alternative firmwares | 1 |
| Firmware upgrade | supported |
| ATA version | 6 |
| Advanced Format | not supported |
| Units tested | 1 |
| Times tested | 1 |
| Performance | |
| Maximum interface speed | 100 MB/s |
| Maximum buffered read speed | 83 MB/s |
| Maximum read speed | 31 MB/s |
| Minimum average access time | 19.80 msec |
| Cache buffer | 8 MB |
| Volatile write cache | supported |
| Read look-ahead | supported |
| Command Queuing Optimization (TCQ) | not supported |
| Advanced Power Management (APM) | supported |
| Acoustic Management (AAM) | not supported |
| Reliability | |
| Count of sensors | 17 |
| Free-fall Control | not supported |
| SMART Command Transport (SCT) | not supported |
| Duration of full self test | 111 minutes |
| Maximum temperature | 61°C (141°F) |
| Average maximum temperature | 61°C (141°F) |
| Security | |
| Drive access restriction | supported |
| Enhanced security erase | not supported |
| Instant data destruction | not supported |
| Host protected area (HPA) | not supported |