Parameters of FUJITSU MHM2200AT with Firmware 3D23
General information | |
---|---|
Trademark | Fujitsu |
Model | FUJITSU MHM2200AT |
Capacity | 18.6 GB |
Interface | PATA |
Maximum Ultra DMA mode | 4 |
Firmware | 3D23 |
Firmware upgrade | not supported |
ATA version | 5 |
Advanced Format | not supported |
Units tested | 1 |
Times tested | 1 |
Performance | |
Maximum interface speed | 66,7 MB/s |
Maximum buffered read speed | 28 MB/s |
Maximum read speed | 16 MB/s |
Minimum average access time | 20.50 msec |
Cache buffer | 2 MB |
Volatile write cache | supported |
Read look-ahead | supported |
Command Queuing Optimization (TCQ) | not supported |
Advanced Power Management (APM) | supported |
Acoustic Management (AAM) | not supported |
Reliability | |
Count of sensors | 14 |
Free-fall Control | not supported |
SMART Command Transport (SCT) | not supported |
Duration of full self test | 32 minutes |
Temperature sensor | not supported |
Security | |
Drive access restriction | supported |
Enhanced security erase | not supported |
Data destruction time | 16 minutes |
Instant data destruction | not supported |
Host protected area (HPA) | supported |
Host protected area password | supported |