Parameters of FUJITSU MHV2080AT PL with Firmware 008300A1
General information | |
---|---|
Trademark | Fujitsu |
Model | FUJITSU MHV2080AT PL |
Capacity | 74.5 GB |
Interface | PATA |
Maximum Ultra DMA mode | 5 |
Firmware | 008300A1 |
Alternative firmwares | 1 |
Firmware upgrade | supported |
ATA version | 7 |
Advanced Format | not supported |
Units tested | 2 |
Times tested | 10 |
Performance | |
Maximum interface speed | 100 MB/s |
Maximum buffered read speed | 87 MB/s |
Maximum read speed | 28 MB/s |
Minimum average access time | 19.70 msec |
Cache buffer | 8 MB |
Volatile write cache | supported |
Read look-ahead | supported |
Command Queuing Optimization (TCQ) | not supported |
Advanced Power Management (APM) | supported |
Acoustic Management (AAM) | not supported |
Reliability | |
Count of sensors | 19 |
Free-fall Control | not supported |
SMART Command Transport (SCT) | supported |
Duration of full self test | 70 minutes |
Maximum temperature | 48°C (118°F) |
Average maximum temperature | 42°C (107°F) |
Security | |
Drive access restriction | supported |
Enhanced security erase | not supported |
Data destruction time | 80 minutes |
Instant data destruction | not supported |
Host protected area (HPA) | not supported |