Parameters of FUJITSU MHW2080AT with Firmware 0000000B
| General information | |
|---|---|
| Trademark | Fujitsu |
| Model | FUJITSU MHW2080AT |
| Capacity | 74.5 GB |
| Interface | PATA |
| Maximum Ultra DMA mode | 5 |
| Firmware | 0000000B |
| Firmware upgrade | supported |
| ATA version | 7 |
| Advanced Format | not supported |
| Units tested | 5 |
| Times tested | 7 |
| Performance | |
| Maximum interface speed | 100 MB/s |
| Maximum buffered read speed | 89 MB/s |
| Maximum read speed | 35 MB/s |
| Minimum average access time | 19.70 msec |
| Cache buffer | 8 MB |
| Volatile write cache | supported |
| Read look-ahead | supported |
| Command Queuing Optimization (TCQ) | not supported |
| Advanced Power Management (APM) | supported |
| Acoustic Management (AAM) | supported |
| Reliability | |
| Count of sensors | 19 |
| Free-fall Control | not supported |
| SMART Command Transport (SCT) | supported |
| Duration of full self test | 70 minutes |
| Critical maximum temperature | 65°C (149°F) |
| Recommended maximum temperature | 60°C (140°F) |
| Maximum temperature | 56°C (132°F) |
| Average maximum temperature | 50°C (122°F) |
| Security | |
| Drive access restriction | supported |
| Enhanced security erase | not supported |
| Data destruction time | 80 minutes |
| Instant data destruction | not supported |
| Host protected area (HPA) | supported |
| Host protected area password | supported |