Parameters of Fake WD5000A with Firmware 05.00H.4
| General information | |
|---|---|
| Trademark | Fake |
| Model | WD5000A |
| Capacity | 500.1 GB (465.7 GiB) |
| Form-factor | 3.5" |
| Type | HDD |
| Interface | SATA |
| SATA version | 3.0 |
| Firmware | 05.00H.4 |
| Alternative firmwares | 1 |
| Firmware upgrade | supported |
| ATA version | 0 |
| Advanced Format | supported |
| Units tested | 1 |
| Times tested | 1 |
| Performance | |
| Maximum interface speed | 600 MB/s |
| Maximum buffered read speed | 408 MiB/s |
| Maximum read speed | 178 MiB/s |
| Minimum average access time | 15.78 msec |
| Volatile write cache | supported |
| Read look-ahead | supported |
| Native command queuing (NCQ) | supported |
| Advanced power management (APM) | not supported |
| Acoustic management (AAM) | supported |
| Reliability | |
| Count of sensors | 22 |
| Free-fall control | not supported |
| SMART command transport (SCT) | supported |
| Full self-test time | 65 minutes |
| Critical maximum temperature | 85°C (185°F) |
| Recommended maximum temperature | 60°C (140°F) |
| Maximum temperature | 40°C (104°F) |
| Average maximum temperature | 40°C (104°F) |
| Security | |
| Drive access restriction | supported |
| Enhanced security erase | supported |
| Data destruction time | 66 minutes |
| Instant data destruction | not supported |
| Host protected area (HPA) | supported |
| Host protected area password | supported |
| Trusted computing | not supported |