Parameters of Intenso SSD Sata III with Firmware P1003B
| General information | |
|---|---|
| Trademark | Intenso |
| Model | Intenso SSD Sata III |
| Capacity | 126.7 GB (117.9 GiB) |
| Type | SSD |
| Interface | SATA |
| SATA version | 3.1 |
| Controller | Silicon Motion |
| Firmware | P1003B |
| Alternative firmwares | 7 |
| Firmware upgrade | supported |
| ATA version | ACS-2 |
| Advanced Format | not supported |
| Units tested | 1 |
| Times tested | 3 |
| Performance | |
| Maximum interface speed | 600 MB/s |
| Maximum buffered read speed | 404 MiB/s |
| Maximum read speed | 304 MiB/s |
| Minimum average access time | 0.7 msec |
| Volatile write cache | supported |
| Read look-ahead | supported |
| Native command queuing (NCQ) | supported |
| Advanced power management (APM) | not supported |
| Device sleep (DevSleep) | supported |
| Clearing unused data (TRIM) | supported |
| Reliability | |
| Count of sensors | 30 |
| SMART command transport (SCT) | supported |
| Full self-test time | 1 minutes |
| Recommended maximum temperature | 100°C (212°F) |
| Maximum temperature | 47°C (116°F) |
| Average maximum temperature | 47°C (116°F) |
| Security | |
| Drive access restriction | supported |
| Enhanced security erase | supported |
| Data destruction time | 4 minutes |
| Instant data destruction | not supported |
| Host protected area (HPA) | supported |
| Host protected area password | supported |
| Trusted computing | not supported |