Parameters of Lexar SSD with Firmware H190117H
| General information | |
|---|---|
| Trademark | Lexar |
| Model | Lexar SSD |
| Capacity | 119.2 GB |
| Interface | SATA |
| SATA version | 3.2 |
| Form-factor | 2.5" |
| Firmware | H190117H |
| Alternative firmwares | 4 |
| Firmware upgrade | supported |
| SSD controller | Maxiotek |
| ATA version | ACS-2 |
| Advanced Format | not supported |
| Units tested | 1 |
| Times tested | 1 |
| Performance | |
| Maximum interface speed | 600 MB/s |
| Maximum buffered read speed | 378 MB/s |
| Maximum read speed | 345 MB/s |
| Minimum average access time | 0.12 msec |
| Volatile write cache | supported |
| Read look-ahead | supported |
| Command Queuing Optimization (NCQ) | supported |
| Advanced Power Management (APM) | not supported |
| Device Sleep (DevSleep) | not supported |
| TRIM | supported |
| Reliability | |
| Count of sensors | 26 |
| SMART Command Transport (SCT) | supported |
| Duration of full self test | 2 minutes |
| Maximum temperature | 48°C (118°F) |
| Average maximum temperature | 48°C (118°F) |
| Security | |
| Drive access restriction | supported |
| Enhanced security erase | supported |
| Data destruction time | 2 minutes |
| Instant data destruction | not supported |
| Host protected area (HPA) | not supported |
| Trusted computing | not supported |