Parameters of MB0500EBNCR with Firmware HPG2
| General information | |
|---|---|
| Trademark | Hewlett Packard |
| Model | MB0500EBNCR |
| Capacity | 500.1 GB (465.7 GiB) |
| Form-factor | 3.5" |
| Type | HDD |
| Interface | SATA |
| SATA version | 2.6 |
| Firmware | HPG2 |
| Alternative firmwares | 1 |
| Firmware upgrade | supported |
| ATA version | 8 (ACS) |
| Advanced Format | not supported |
| Units tested | 3 |
| Times tested | 4 |
| Performance | |
| Maximum interface speed | 300 MB/s |
| Maximum buffered read speed | 236 MiB/s |
| Maximum read speed | 130 MiB/s |
| Minimum average access time | 12.23 msec |
| Volatile write cache | supported |
| Read look-ahead | supported |
| Native command queuing (NCQ) | supported |
| Advanced power management (APM) | not supported |
| Acoustic management (AAM) | not supported |
| Clearing unused data (TRIM) | not supported |
| Rotation rate | 7200 rpm |
| Reliability | |
| Count of sensors | 23 |
| Free-fall control | not supported |
| SMART command transport (SCT) | supported |
| Full self-test time | 85 minutes |
| Critical maximum temperature | 85°C (185°F) |
| Recommended maximum temperature | 60°C (140°F) |
| Maximum temperature | 50°C (122°F) |
| Average maximum temperature | 42°C (107°F) |
| Security | |
| Drive access restriction | not supported |
| Enhanced security erase | not supported |
| Instant data destruction | not supported |
| Host protected area (HPA) | not supported |
| Trusted computing | not supported |