Parameters of MB2000EAZNL with Firmware HPG1
| General information | |
|---|---|
| Trademark | Hewlett Packard |
| Model | MB2000EAZNL |
| Capacity | 1.8 TB |
| Interface | SATA |
| SATA version | 2.6 |
| Form-factor | 3.5" |
| Firmware | HPG1 |
| Alternative firmwares | 1 |
| Firmware upgrade | supported |
| ATA version | 8 (ACS) |
| Advanced Format | not supported |
| Units tested | 1 |
| Times tested | 1 |
| Performance | |
| Maximum interface speed | 300 MB/s |
| Maximum buffered read speed | 222 MB/s |
| Maximum read speed | 48 MB/s |
| Minimum average access time | 26.72 msec |
| Volatile write cache | supported |
| Read look-ahead | supported |
| Command Queuing Optimization (NCQ) | supported |
| Advanced Power Management (APM) | not supported |
| Acoustic Management (AAM) | not supported |
| Rotation rate | 7200 rpm |
| Reliability | |
| Count of sensors | 23 |
| Free-fall Control | not supported |
| SCT Transport | supported |
| Duration of full self test | > 255 minutes |
| Critical maximum temperature | 85°C (185°F) |
| Recommended maximum temperature | 60°C (140°F) |
| Maximum temperature | 57°C (134°F) |
| Average maximum temperature | 57°C (134°F) |
| Security | |
| Drive access restriction | not supported |
| Enhanced security erase | not supported |
| Instant data destruction | not supported |
| Host protected area (HPA) | not supported |
| Trusted Computing | not supported |