Parameters of MTFDDAK128MAM-1J1 with Firmware 0809
| General information | |
|---|---|
| Trademark | Micron |
| Model | MTFDDAK128MAM-1J1 |
| Capacity | 128 GB (119.2 GiB) |
| Form-factor | 2.5" |
| Type | SSD |
| Interface | SATA |
| SATA version | 3.0 |
| Controller | Marvell |
| Firmware | 0809 |
| Alternative firmwares | 2 |
| Firmware upgrade | supported |
| ATA version | ACS-2 |
| Advanced Format | not supported |
| Units tested | 7 |
| Times tested | 23 |
| Performance | |
| Maximum interface speed | 600 MB/s |
| Maximum buffered read speed | 424 MiB/s |
| Maximum read speed | 386 MiB/s |
| Minimum average access time | 0.8 msec |
| Volatile write cache | supported |
| Read look-ahead | supported |
| Native command queuing (NCQ) | supported |
| Advanced power management (APM) | supported |
| Device sleep (DevSleep) | not supported |
| Clearing unused data (TRIM) | supported |
| Reliability | |
| Count of sensors | 23 |
| SMART command transport (SCT) | supported |
| Full self-test time | 9 minutes |
| Critical maximum temperature | 75°C (167°F) |
| Recommended maximum temperature | 70°C (158°F) |
| Temperature sensor | not supported |
| Security | |
| Drive access restriction | supported |
| Enhanced security erase | supported |
| Data destruction time | 2 minutes |
| Instant data destruction | not supported |
| Host protected area (HPA) | not supported |
| Trusted computing | not supported |