Parameters of MTFDDAK256TDL with Firmware M5MU030
| General information | |
|---|---|
| Trademark | Micron |
| Model | MTFDDAK256TDL |
| Capacity | 238.4 GB |
| Interface | SATA |
| SATA version | 3.3 |
| Form-factor | 2.5" |
| Firmware | M5MU030 |
| Firmware upgrade | supported |
| SSD controller | Marvell |
| ATA version | ACS-4 |
| Advanced Format | not supported |
| Units tested | 1 |
| Times tested | 1 |
| Performance | |
| Maximum interface speed | 600 MB/s |
| Maximum buffered read speed | 431 MB/s |
| Maximum read speed | 398 MB/s |
| Minimum average access time | 0.6 msec |
| Volatile write cache | supported |
| Read look-ahead | supported |
| Command Queuing Optimization (NCQ) | supported |
| Advanced Power Management (APM) | not supported |
| Device Sleep (DevSleep) | supported |
| TRIM | supported |
| Reliability | |
| Count of sensors | 23 |
| SMART Command Transport (SCT) | supported |
| Duration of full self test | 5 minutes |
| Critical maximum temperature | 71°C (159°F) |
| Recommended maximum temperature | 70°C (158°F) |
| Maximum temperature | 45°C (113°F) |
| Average maximum temperature | 45°C (113°F) |
| Security | |
| Drive access restriction | supported |
| Enhanced security erase | supported |
| Data destruction time | 2 minutes |
| Instant data destruction | not supported |
| Host protected area (HPA) | not supported |
| Trusted computing | not supported |