Parameters of SEAGATE ST4000NM0135 with Firmware 1.5504
| General information | |
|---|---|
| Trademark | Seagate |
| Model | SEAGATE ST4000NM0135 |
| Capacity | 4 TB (3.6 TiB) |
| Type | HDD |
| Interface | SATA |
| SATA version | 3.2 |
| Firmware | 1.5504 |
| Firmware upgrade | supported |
| ATA version | ACS-3 |
| Advanced Format | not supported |
| Units tested | 1 |
| Times tested | 1 |
| Performance | |
| Maximum interface speed | 600 MB/s |
| Maximum buffered read speed | 39 MiB/s |
| Maximum read speed | 38 MiB/s |
| Minimum average access time | 11.77 msec |
| Volatile write cache | not supported |
| Read look-ahead | not supported |
| Native command queuing (NCQ) | supported |
| Advanced power management (APM) | not supported |
| Acoustic management (AAM) | not supported |
| Clearing unused data (TRIM) | not supported |
| Rotation rate | 7200 rpm |
| Reliability | |
| Count of sensors | 8 |
| Free-fall control | not supported |
| SMART command transport (SCT) | not supported |
| Full self-test time | > 255 minutes |
| Maximum temperature | 22°C (71°F) |
| Average maximum temperature | 22°C (71°F) |
| Security | |
| Drive access restriction | not supported |
| Enhanced security erase | not supported |
| Instant data destruction | not supported |
| Host protected area (HPA) | not supported |
| Trusted computing | not supported |