Parameters of SPCC SSD110 with Firmware 505ABBF0
| General information | |
|---|---|
| Trademark | Silicon Power |
| Model | SPCC SSD110 |
| Capacity | 111.7 GB |
| Interface | SATA |
| SATA version | 3.0 |
| Firmware | 505ABBF0 |
| Alternative firmwares | 5 |
| Firmware upgrade | supported |
| SSD controller | SandForce |
| ATA version | 8 (ACS) |
| Advanced Format | not supported |
| Units tested | 2 |
| Times tested | 2 |
| Performance | |
| Maximum interface speed | 600 MB/s |
| Maximum buffered read speed | 386 MB/s |
| Maximum read speed | 320 MB/s |
| Minimum average access time | 0.20 msec |
| Volatile write cache | supported |
| Read look-ahead | supported |
| Command Queuing Optimization (NCQ) | supported |
| Advanced Power Management (APM) | supported |
| Device Sleep (DevSleep) | not supported |
| TRIM | supported |
| Reliability | |
| Count of sensors | 22 |
| SCT Transport | supported |
| Duration of full self test | 48 minutes |
| Temperature sensor | not supported |
| Security | |
| Drive access restriction | supported |
| Enhanced security erase | not supported |
| Data destruction time | 2 minutes |
| Instant data destruction | not supported |
| Host protected area (HPA) | supported |
| Host protected area password | not supported |
| Trusted computing | not supported |