Parameters of ST2000DL001 with Firmware CC92
| General information | |
|---|---|
| Trademark | Seagate |
| Model | ST2000DL001 |
| Capacity | 2 TB (1.8 TiB) |
| Type | HDD |
| Interface | SATA |
| SATA version | 2.6 |
| Firmware | CC92 |
| Firmware upgrade | supported |
| ATA version | 8 (ACS) |
| Advanced Format | supported |
| Units tested | 1 |
| Times tested | 1 |
| Performance | |
| Maximum interface speed | 300 MB/s |
| Maximum buffered read speed | 187 MiB/s |
| Maximum read speed | 129 MiB/s |
| Minimum average access time | 18.55 msec |
| Volatile write cache | supported |
| Read look-ahead | supported |
| Native command queuing (NCQ) | not supported |
| Advanced power management (APM) | not supported |
| Acoustic management (AAM) | supported |
| Clearing unused data (TRIM) | not supported |
| Rotation rate | 5900 rpm |
| Reliability | |
| Count of sensors | 25 |
| Free-fall control | not supported |
| SMART command transport (SCT) | supported |
| Full self-test time | > 255 minutes |
| Critical maximum temperature | 60°C (140°F) |
| Recommended maximum temperature | 55°C (131°F) |
| Maximum temperature | 57°C (134°F) |
| Average maximum temperature | 57°C (134°F) |
| Security | |
| Drive access restriction | supported |
| Enhanced security erase | supported |
| Data destruction time | 344 minutes |
| Instant data destruction | not supported |
| Host protected area (HPA) | supported |
| Host protected area password | supported |
| Trusted computing | not supported |