Parameters of SanDisk SD6SP1M128G1002 with Firmware X230500
General information | |
---|---|
Trademark | SanDisk |
Model | SanDisk SD6SP1M128G1002 |
Capacity | 119.2 GB |
Interface | SATA |
SATA version | 3.0 |
Firmware | X230500 |
Alternative firmwares | 1 |
Firmware upgrade | supported |
SSD controller | Marvell |
ATA version | 8 (ACS) |
Advanced Format | not supported |
Units tested | 1 |
Times tested | 1 |
Performance | |
Maximum interface speed | 600 MB/s |
Maximum buffered read speed | 44 MB/s |
Maximum read speed | 43 MB/s |
Minimum average access time | 0.20 msec |
Volatile write cache | supported |
Read look-ahead | supported |
Command Queuing Optimization (NCQ) | supported |
Advanced Power Management (APM) | supported |
Device Sleep (DevSleep) | supported |
TRIM | supported |
Reliability | |
Count of sensors | 20 |
SMART Command Transport (SCT) | not supported |
Duration of full self test | 10 minutes |
Maximum temperature | 61°C (141°F) |
Average maximum temperature | 61°C (141°F) |
Security | |
Drive access restriction | supported |
Enhanced security erase | supported |
Data destruction time | 2 minutes |
Instant data destruction | not supported |
Host protected area (HPA) | supported |
Host protected area password | supported |
Trusted computing | not supported |