Parameters of SanDisk SD9SN8W128G1002 with Firmware X6103002
| General information | |
|---|---|
| Trademark | SanDisk |
| Model | SanDisk SD9SN8W128G1002 |
| Capacity | 119.2 GB |
| Interface | SATA |
| SATA version | 3.3 |
| Form-factor | M.2 |
| Firmware | X6103002 |
| Firmware upgrade | supported |
| SSD controller | Marvell |
| ATA version | ACS-4 |
| Advanced Format | not supported |
| Units tested | 6 |
| Times tested | 11 |
| Performance | |
| Maximum interface speed | 600 MB/s |
| Maximum read speed | 410 MB/s |
| Minimum average access time | 0.9 msec |
| Volatile write cache | supported |
| Read look-ahead | supported |
| Command Queuing Optimization (NCQ) | supported |
| Advanced Power Management (APM) | supported |
| Device Sleep (DevSleep) | supported |
| TRIM | supported |
| Reliability | |
| Count of sensors | 25 |
| SMART Command Transport (SCT) | not supported |
| Duration of full self test | 10 minutes |
| Maximum temperature | 72°C (161°F) |
| Average maximum temperature | 58°C (136°F) |
| Security | |
| Drive access restriction | supported |
| Enhanced security erase | supported |
| Data destruction time | 2 minutes |
| Instant data destruction | not supported |
| Host protected area (HPA) | not supported |
| Trusted computing | not supported |