Parameters of SanDisk SDSSDHP128G with Firmware X2316RL
| General information | |
|---|---|
| Trademark | SanDisk |
| Model | SanDisk SDSSDHP128G |
| Capacity | 128 GB (119.2 GiB) |
| Type | SSD |
| Interface | SATA |
| SATA version | 3.0 |
| Controller | Marvell |
| Firmware | X2316RL |
| Alternative firmwares | 2 |
| Firmware upgrade | supported |
| ATA version | 8 (ACS) |
| Advanced Format | not supported |
| Units tested | 31 |
| Times tested | 58 |
| Performance | |
| Maximum interface speed | 600 MB/s |
| Maximum read speed | 478 MiB/s |
| Minimum average access time | 0.9 msec |
| Volatile write cache | supported |
| Read look-ahead | supported |
| Native command queuing (NCQ) | supported |
| Advanced power management (APM) | supported |
| Device sleep (DevSleep) | not supported |
| Clearing unused data (TRIM) | supported |
| Reliability | |
| Count of sensors | 20 |
| SMART command transport (SCT) | not supported |
| Full self-test time | 10 minutes |
| Maximum temperature | 73°C (163°F) |
| Average maximum temperature | 45°C (113°F) |
| Security | |
| Drive access restriction | supported |
| Enhanced security erase | supported |
| Data destruction time | 2 minutes |
| Instant data destruction | not supported |
| Host protected area (HPA) | supported |
| Host protected area password | supported |
| Trusted computing | not supported |