Parameters of SanDisk SSD PLUS 480GB with Firmware UG4004RL
General information | |
---|---|
Trademark | SanDisk |
Model | SanDisk SSD PLUS 480GB |
Capacity | 447.1 GB |
Interface | SATA |
SATA version | 3.2 |
Form-factor | 2.5" |
Firmware | UG4004RL |
Alternative firmwares | 7 |
Firmware upgrade | supported |
SSD controller | Marvell |
ATA version | ACS-3 |
Advanced Format | not supported |
Units tested | 14 |
Times tested | 16 |
Performance | |
Maximum interface speed | 600 MB/s |
Maximum read speed | 302 MB/s |
Minimum average access time | 0.23 msec |
Volatile write cache | supported |
Read look-ahead | supported |
Command Queuing Optimization (NCQ) | supported |
Advanced Power Management (APM) | supported |
Device Sleep (DevSleep) | supported |
TRIM | supported |
Reliability | |
Count of sensors | 25 |
SMART Command Transport (SCT) | not supported |
Duration of full self test | 83 minutes |
Maximum temperature | 75°C (167°F) |
Average maximum temperature | 59°C (138°F) |
Security | |
Drive access restriction | supported |
Enhanced security erase | not supported |
Data destruction time | 2 minutes |
Instant data destruction | not supported |
Host protected area (HPA) | supported |
Host protected area password | supported |
Trusted computing | not supported |